Karcepts KFSB-AP-XX Manuel d'utilisateur télécharger pdf (Page 5)

1. Solid Mount/Center Section Installation (continued...)

E. Install the solid mount/center section assembly onto the factory sway bar

mounting brackets with the provided M10x25 flange bolts and torque to 29 ft-

lbs with a 14mm socket. Do not be alarmed if observing high friction levels

when trying to rotate the bar at this time. With use, the bushings will break-in

and free up quickly.

F. Slide a clamp collar over each end of the splined center section. Leave the

collar screws loose. There is no need to center the bar perfectly at this time.

You will not be centering the bar based off how much shaft is protruding from

the sides of the mounts as that does not always give a clear indication of true

center (due to subframe position, eccentric alignment bolt positions, as well as

excess hole clearance in the factory sway bar mounting brackets to the frame).

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Karcepts KFSB-AP-XX Manuel d'utilisateur Page 5